More problems... I updated to 7.10. Now the temp is off. I have a manuell tempprobe that always have been in sync with the profilux. Now after the update the profilux reads 2 C to high. The p4 is reset with factory settings then the settings is imported via file. This is both direct on the p4 and my exbox 2, so on two different tanks. What to do?
Update! I did a reset on the p4 and disconnected all pab and did a reset in the pab. Redid all settings (no backup). Then added pab one efter one. Allso now the exbox 2 is last in the chain. The p4 now show the correct temp. The exbox still is 1,3 C to high. I allso swapped the tempprobes. Same values so its the exbox 2. Tested before and after I updated the exbox with new firmware. Still the same.
Results 1 to 10 of 19
Threaded View
-
05.01.2018, 08:42 #12
Erfahrener Benutzer
- Join Date
- 30.03.2011
- Location
- helsingborg
- Posts
- 177
Last edited by faltaren; 05.01.2018 at 19:27.
Reply With Quote
Bookmarks