did you try this?
http://www.aquariumcomputer.com/Foru...ead.php?t=1770
the ProfiLux is not the problem - port forwarding works for many customers - and it works here with my ProfiLux
same as for MSHUR:
please post the relevant router settings (screenshots), maybe we find the problem in this way
Question: What is the IP "from outside" of your router?
maybe also post your router type. it make it easy to find a howto and then we can help better.
Thanks everyone. I think my router was the problem. Its over 3 years old, so I decided to buy a new routerm, and wireless bridge for the P3. I will post up later or tomorrow my progress.
Again, thanks for all the help here, I am learning a TON!
Ok here is where I am at.
I still cannot conect via internet:mad:
I bought a new Linksys WRT400N Router, and a WRT610N wireless bridge.
As on now I can access the P3 on any computer on my network, but I cannot figure out the port forwarding.
my routers numbers are image 1
MY bridge IP is 192.168.1.105
P3 settings are
IP 192.168.1.106
Subnet 255.255.255.0
default gateway 192.168.1.105 (IP of bridge)
Like I said, I can connect to the P3 from any computer on my network.
Here is an image of my routers port settings. No matter what I put them at it doesnt work.
My P3 is set for port 80
I also set up a DDNS and have it routed successfully to my router, but it will not work when I try forwarding the ports...
Any suggestions?
Proof that I can access via computer
you still did not answer my question:
what address are you trying to access? Or do you have a dynamic DNS?Question: What is the IP "from outside" of your router?
Bookmarks