Do as mentioned above.
NOTE
When you have the doser connected to the S1-S4 port, it will automatically be assigned to the S1-S4 switch channels by default.
Since you currently have a Powerbar 5.1, also assigned to S1-S5, there will be a conflict which is causing the 2nd pump to run based on the existing function assigned to S2 (for the powerbar).
The solution is to assign your dosing pump heads to switch channels that are not being used by the powerbar.
For example:
- Powerbar 5.1: Currently assigned to S1-S5
- Dosing unit: Assign to S6-S9
You can assign the numbering of your dosing pump by going to the
Switch channels and outlets settings page, enabling digital comm. for S1-S4, click Program devices, select the doser, set the first pump head to start at 6, click OK.
After that is completed, go to your S6-S9 switch channels and set each function to:
- S6: Dosing pump 1
- S7: Dosing pump 2
- S8: Dosing pump 3
- S9: Dosing pump 4
Go to those dosing pump channels and setup your schedules.
Bookmarks