Hi,
you can accomplish your plan with your ProfiLux as follows:
At the 1-10V-interface, where the fans are connected, select the humidity sensor as function, set U min. to a value where the fans run on the desired min. speed and U max. for the desired max. speed.
Then, when the nominal value of the humidity sensor is set to 50%, the voltage of the 1-10V-interface will start increasing when the actual value goes above 50%.
Further information can be found in the programming guide at point 8.4.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks