Hi everyone!
I am trying to set up an ATO system to top off the RODI water reserve that compensates the water evaporation of my main tank.
I have dully followed the tuto for How to setup ATO control with Profilux, but after trying a couple of times, it seems my ATO system isn't responding to the min. and max levels.
Here is my set-up:
- 1 float GHL Level sensor for the max. water level point (sensor no. 1), plugged into the Purple port (Level 1 / 2)
- 1 optical GHL Level sensor for the min. water level point (sensor no. 2), plugged into the Green port (Level 3 / 4)
I am getting confused as to why the tuto video speaks about sensor no. 1 and sensor no. 2 at 2:36.
Do I need a Level Sensor Splitter Cable to have both sensors connected to the same port, so no. 1 is recognised as Level 1 and no. 2 is as Level 2?
Thanks for your help!
Bookmarks