Hey!
I have the fibaro RGB W led controller. Basically it comes with 4 0-10v inputs and 4 PWM outputs to control a led strip of up to 140W.
I want to use it to control a backlight panel.
Can I connect the 0-10v outputs from the Profilux 4 to the Fibaro controller? If so:
- what cable do I need to get 3 0-10v outputs from the Profilux?
- the Fibaro RGBW can be configured to have (or not) a pull-up resistor on each 0-10v input. Does the Profilux 0-10v outputs require a pull-up resistor?
Anything else I should keep in mind?
Cheers,
Bookmarks