Unplugged my lights and now one of them will not start up the other took about 10 minutes to boot up. The GHL logo flashes every 3 seconds.
Unplugged my lights and now one of them will not start up the other took about 10 minutes to boot up. The GHL logo flashes every 3 seconds.
Last edited by Skydivingcatfan; 17.06.2021 at 00:33. Reason: Can not get video to work
Case being handled via support ticket system.
No support or warranty issues over PM!
Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Creating a support ticket
For support or warranty issues, create a support ticket by clicking here.
I have exactly the some problem!
I had an old ticket for this problem but got no solution so I made a new on yesterday.
I would be grateful if you could write me your solution!!!
Thank you!
Unplug the connector between the power supply and the light.
Yes! But after electricity power off and if I am away from home reef will stay at darkness!
Was there any fix for this issue, besides using the circular connector? My LX 7206 also have this problem. More often than not they don't turn back on when I unplug them from the wall. I was away on vacation for 2 weeks and some of the lights didn't turn back on after a power outage.
Hello,
If it's a issue that happens frequently, I can suggest you add a time delay relay. (Personal advice, not an official GHL advice).
Gaël
No support or warranty issues over PM!
Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Creating a support ticket
For support or warranty issues, create a support ticket by clicking here.
Thanks for the suggestion. Do you mean on the circular connector side? I would be willing to do that providing I can find the mating circular connectors to wire out to the relay. Or do you mean for the wall power? In that case, I should just get another powerbar to plug them into. Then I could manually power cycle them in GHL Connect until it powers up properly.
I was hoping GHL would be able to implement something like an automatic reboot when the Mitras goes into that state where the GHL logo is blinking blue after powering up. But this is wishful thinking, I don't know what is causing the issue or what's possible in that error state.
The power outages aren't frequent. Just so happened that one occurred a few weeks ago and that was the second day into my vacation.
Bookmarks