-
I wanted to post the resolution on this as I know once something moves to opening a ticket some of these never get resolved on here which doesn't help anyone.
Germany was unable to replicate this issue and understandably so. This was a user error caused by myself. I had to replace the circuit board in my KHD due to water damage from my probe. Once that was complete I logged into GCC in order to set the new SN for the new circuit board. In doing so, I did not disconnect the other PAB devices and basically reset all of the serial numbers to the new serial number of the KHD. There was no noticeable change to the system, nothing quit, nothing even showed wrong in the system UNTIL I reset the PAB system after the latest firmware upgrade. When going to assign all of my PAB devices everything that was discovered all showed the same device and serial number. I am going to attempt to go back and reset each device one at a time to its original device and serial number. On a positive note, everything continued to operate as if nothing had happened , except the actual KHD unit will not operate. I hope that clearing up all of the devices resolves that issue. More to come...
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks