Is it possible to get notification is Actual current is lower og higher than a specified threshold from a socket on the pab powerbar?
Is it possible to get notification is Actual current is lower og higher than a specified threshold from a socket on the pab powerbar?
not yet but this is on our development roadmap
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Is this possible yet?
no.
Hopefully it goes live soon. This would be very helpful for equipment failures.
i hope it
Any expected completion date for this?
Essential feature for those that have suffered a pump lockup during a vacation. Good thing I have a temp sensor in the sump too in order to catch this potential over heat condition. Frozen would pull excess current but no way to know that outside of socket load monitoring.
Sent from my iPhone using Tapatalk
Thankfully I have two return pumps. Last week one of them died and I didn't notice it right away. With something like this, I could have been alerted to the issue much sooner.
Any News on this being added?
Bookmarks