Originally Posted by
Vinny
We have this section explained in our P4 Resource Guide, page 110.
Check it out if you want to see it with pictures of the steps.
How to create a socket delay after maintenance mode ends
CREATE THE 1ST PL FUNCTION: Maintenance mode delay
1. Go to the PROGRAMMABLE LOGIC settings page.
2. Select an unused Gate and set the function to DELAYED OFF.
3. Set the Input to MAINTENANCE and specify how long to delay the reaction.
4. Type-in a description and click OK.
CREATE THE 2nd PL FUNCTION: Combine first PL with another function
1. Select another unused Gate and set this function to AND.
2. Set Input 1 to any existing function you wish to assign.
For example, if you currently have the skimmer set to turn OFF for a feed pause, youÂ’d select FILTER.
If you do not have any existing function assigned to the skimmer, select ALWAYS ON.
3. Set Input 2 to PROGRAMMABLE LOGIC and select the PL Gate number you used when you created the 1st PL function (Maintenance delay). Invert this function.
For example, if you created the PL function on Gate 1, select PROGRAMMABLE LOGIC 1.
4. Type-in a description and click OK.
ASSIGN THE 2nd PL FUNCTION TO A POWERBAR OUTLET
1. Go to the SWITCH CHANNELS AND OUTLETS settings page and select the Powerbar outlet that has the skimmer connected to it.
2. Set this function to PROGRAMMABLE LOGIC and select the Gate number you used when you created the 2nd PL function.
3. Type-in a description and click OK.
4. Click SAVE CHANGES.
Bookmarks