You can do this using 2 Programmable Logic commands.

Here’s how to create a delayed ON reaction for a feed pause:

CREATE THE 1ST PL FUNCTION: Maintenance mode delay
1. Go to the PROGRAMMABLE LOGIC settings page.
2. Select an unused Gate and set the function to DELAYED ON.
3. Set the Input to FILTER (select filter number) and specify how long to delay the reaction. In this case, it would be 120 seconds.
4. Type-in a description and click OK.

CREATE THE 2nd PL FUNCTION: Combine first PL with another function
1. Select another unused Gate and set this function to AND.
2. Set Input 1 to FILTER and select the Feed pause number to use for this function.
3. Set Input 2 to PROGRAMMABLE LOGIC and select the PL Gate number you used when you created the 1st PL function (Maintenance delay).
*** For example, if you created the PL function on Gate 1, select PROGRAMMABLE LOGIC 1.
4. Type-in a description and click OK.

ASSIGN THE 2nd PL FUNCTION TO A POWERBAR OUTLET
1. Go to the SWITCH CHANNELS AND OUTLETS settings page and select the Powerbar outlet that has the ATO connected to it.
2. Set this function to PROGRAMMABLE LOGIC and select the Gate number you used when you created the 2nd PL function.
3. Type-in a description and click OK.
4. Click SAVE CHANGES.