-
S-L-port BOB
Hi,
I've connected the profilux S port via a S-L port BOB to 4 relays. I tried to assign switch channels to the relays, with the ' Program digital powerbar ' button on the ' switch channels and outlets' page in GCC.
This does not work, I can't get the relay controlled.
Is there another way I should be doing this?
Thanks for the help!
-
Hi there,
Exactly what device do you have connected to the S/L breakout box?
Which ProfiLux controller do you have? P4 or P4e?
-
Hi,
I have the P4, and the relay is a 12V 4 Channel Relay Module Board Shield with Optocoupler Road High and Low Level Trigger Relay for Arduino. With the relay I want to control solenoid valves and ATO pumps.
-
Remember that the S- interfaces tolerate max. 10mA.
regards pit
-
relay.jpg
this is the relay, should work or not?
-
I don't know how much mA need the board
-
Je nach ausführung nimmt das relai 0,36 oder 0,45 watt
http://www.circuitbasics.com/wp-cont...-Datasheet.pdf
0.45 watt / 12 volt macht ca. 0,04 A und damit einen gegrillten port am Profilux. Da musst du noch eine extra stromquelle und einen transistor zwischen klemmen.
-
Nachdem ich mir das höre nochmal angesehen habe, sind die transistoren da evtl. Schon drauf. In dem fall brauchst du mindestens eine extra stromquelle und kannst evtl die schaltausgänge vom profilux direkt nutzen. Hast du ein datenblatt vn dem bord?
-
The trigger current is 5mA, so this should be fine no? I can try with a separate power supply. Is my way to assign the numbering to the switch channels the right way, or is there another way?
Thanks for the help!
-
The trigger current is 5mA, so this should be fine no? I can try with a separate power supply. Is my way to assign the numbering to the switch channels the right way, or is there another way?
Thanks for the help!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks