Heat wave with Profilux 4 (i.e. control value as dynamic value)

[PIWAWT]

I am not sure if I fully understand your suggestion... If I follow your suggestion I will create like two phases: one of heating (according to the timer 1 and value fixed on the sensor temperature 1) and another one of "cooling" (accordning to timer2 and virtual probe Temperature2), right?

right

But...I need to have more control on my wave, I mean I would need to say from 9:00 to 9:15 the nominal value for Temp is 19ºC and from 9:15 to 9:30 the nominal value is 19,4ºC, and so on...

Timer 1
09:00-009:15, 09:30-09:45, 10:00-10:15 and so on
Timer 2
09:15-09:30, 09:45-10:00, 10:15-10:30 and so on

Z= timer
T= temperature; sensor 1= probe, 2= virtual sensor1, 3=virtual sensor2, etc.

G1
Sensor 1 = Z1
AND
Sensor 2 = T1
G2
Sensor1= Z2
AND
Sensor2 = T2
G3
Sensor1=G1
OR
Sensor2=G2

Then each Temp sensor would work only during the seconds, min or hours that the associated timer is on...right?

right

The problem is how to configurate then the socket??

go to the Socket and select "programmierbare Logic 3
The the socket works with the Timer1 or 2 /switch between timer 1 and timer2

One more question: what is then the named: Dynamic nominal value in the menu of the Temperature probe/sensor controls...?

I'm afraid I can't answer that, but I've never dealt with it before.

regards Pit