Hello
I tried to make my powerbar but I don't have power on the output switch.
I have :
- assign devices in Profilux4 system
- my switch is "always on"
What more must be done
thanks
Powerhub.png
Switch channels.png
Powerhub 6D.jpg
Hello
I tried to make my powerbar but I don't have power on the output switch.
I have :
- assign devices in Profilux4 system
- my switch is "always on"
What more must be done
thanks
Powerhub.png
Switch channels.png
Powerhub 6D.jpg
Open the function with a double click and adjust it to your desired functions.
regards Pit
still does not work, I tried ...
Did you also assign everything under "assign devices"?
regards pit
I took pictures of what I set
image.png
image (1).png
image (2).png
image (3).png
Check your power connections going to the connected equipment.
The ProfiLux is showing that the device was correctly assigned.
The PowerHub is also showing that it is sending power to those 6 outlets. See the RED lights are ON. That means the outlets are getting power.
I have already tested the inputs and outputs
. I will contact the SAV ...
Bookmarks