-
Cannot see Vortech Overview in GCC
Hello,
I have been using the VorTech Controller on my P3 for years and recently decided I wanted to go and change the settings a bit. But damned if I can find the "Vortech Overview" tab in GCC?! It's not below Extras as the vortech controller manual suggests. I am using GCC v1090. All the Vortech ecosmart MP40w react to feeding pauses, thunderstorms, etc so I am assuming they are connected still. The PAB communication & status LEDs, and Vortech status LED are on constant. The Vortech RF communication LED flickers on in random patterns every couple seconds. Where can I find the darn thing?
Thanks!
Last edited by scythanith; 14.11.2018 at 16:57.
-
That's odd.
Is the Vortech Controller still showing in your PAB-devices chain?
Please use GCC V1118 and see if the option becomes visible again.
-
I have updated to GCC V1118 and It looks the same. All I see in my PAB chain is serial, humi & temp, & PWC. I went into assign devices and I see my 3 powerbar 6's, Profilux touch and Vortech controller in there. Should I click on all 5 and assign them to this device? No idea why they aren't anymore.
Last edited by scythanith; 15.11.2018 at 18:14.
-
Yes. You must add all devices first
-
They used to be on there. Why would they be taken off, firmware update?
Done, they have been assigned and I now can see the VorTech overview Why would it keep working away but not be assigned?
Last edited by scythanith; 15.11.2018 at 18:43.
-
Maybe a large firmware jump caused this. For that reason, we recommend backing up your settings.
-
I always do. I reloaded my settings once the FW flash was complete but the PAB devices weren't there anymore. All good now though.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks