Hello,
try setting the measurement range again for the Cond.S probe, which is installed on ExBox2.
Goto System->PAB-ExBox2-configuration and set it to Cond.F and back to Cond.S to apply this setting.
Recalibrate and you should be good.
Results 1 to 10 of 12
Thread: Conduct sensor
Threaded View
-
15.10.2018, 09:34 #10
GHL Support Team
- Join Date
- 04.11.2015
- Posts
- 1,068
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Reply With Quote
Bookmarks