Charts not up to date.

[Kodo28]

Hello,

the measurement values are only transmitted when they differ from the previous value or at least once per hour.
This is not uncommon for temperature readings.

Ok but then why do I have for example reading points going down on values by half-hour interval but then at the last point it is showing by hour (My Profilux measurement period is set to 30mn) and this happens many times when checking on all timepoints.

All is reading ok in 30mn interval then it happen to have a reading interval of 1h during two set points.

Ph: 8.25 at 09:06PM
Ph: 8.24 at 09:36PM
Ph: 8.22 at 10:06PM
Ph: 8.20 only at 11:06

The timepoints refer to your ProfiLux4's local time and should be the same on myGHL and webinterface.
We adjusted this in the current version 1.0.7 and notifiy if the difference between local time and device time is bigger than 30 minutes.

When I look actually at the latest graph time points, in both MyGHL and Webinterface they are not the same they defer by 1 minute interval but it can happen sometimes to defer by some minutes.
Time shows the exact same value on all the dashbords and GCC.

I have also another question about the graph timepoints, when looking at the timepoints even by 1 hour interval they show on different timing :
Example: 05:06PM, 06:06PM, 07:06PM, or 05:22PM, 06:22PM, 07:22PM

Is there any way to make the measurement period so that the timepoints would match the graph day time numbers ?
example: 05:00PM, 06:00PM, 07:00PM, 08:00PM or by half-hour 05:30PM, 06:30PM, 07:30PM

See picture below
2018-08-29_192720.png