GHL Control Center 1.1.1.6 and new firmware

[Gael]

Hi,

Good job,

FlowSensor:
Thank you for the opportunity to disable the flow sensor alarm, a long-awaited thing.
It could be perfect, but no :-) I get one or two "beep" of Touch and 2-5 seconds of siren from Profilux and ... a notification alarm by mail (but fortunately no sms).
I only encounter the problem with the return pump which is bigger and takes longer to restart.
It may be necessary to add at least 5 seconds after maintenance / power off until the pumps resume their rated flow.

PowerCut:
Also a suggestion for power cut monitoring and maintenance, you should add a time settings BEFORE activation (like deactivation)
You could replace all three selects and time input box by two time input boxs and two "Manually" check-box:
Time before activation since power cut (0: immediately)
Time before deactivation since power return (0: immediately)
Why? Because it's useless to do something for short power outage.
But for me using maintenance for that is not the best option, i think wee need another option, with maintenance activated we stop many control, (for exemple, my battery is big and can run Profilux and hardware for 10 hours). It's risky to disable overflow protection, ATO, leaks sensors, etc for so long time...
First, you should add "PowerCut" to Programmable logic inputs list.
Next, why not a "During PowerCut" collumn to "Flow-sensor" for constant flow.
Same for "Stream pump", add a "at PowerCut" specific value.
At last, for each "illumination" add a "PowerCut light reduction" checkbox and do like for "Temp.-dep. lightred." where we can set specific reduction.
With these change we can save more battery and keep all security.

Mitras LightBar:
Last thing, Mitras Lightbar configuration in this G.C.C. is broken, if we clic on "Mitras Lightbar" under "Illuminations" we get "Attempted an unsupported operation." box and G.C.C. fail and shutdown. Not a firmware problem because no error with older G.C.C
Capture d’écran 2018-06-16 à 22.35.03.png

Thank

Gael