Hi,
I can't change settings "minimum" and "maximum" in "Sensor graph range".
I can change and save but after reload, i still see old settings.
Capture d’écran 2018-03-04 à 19.50.38.jpg
P4: 7.11
Touch: 1.06
Thank
Gael
Hi,
I can't change settings "minimum" and "maximum" in "Sensor graph range".
I can change and save but after reload, i still see old settings.
Capture d’écran 2018-03-04 à 19.50.38.jpg
P4: 7.11
Touch: 1.06
Thank
Gael
Found a trick:
edit one setting, save
edit second setting, save
->first setting edited is saved.
But it's really painful ..
thanks for the hint
we will have a look into this in GCC 1113
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
I examined this
the problem was that GCC marks the line as changed only when you go to the next line, that means as long as you stay in the table at the same place the setting will not be recognized as changed
moving from the edited line to another would cure it
-> in GCC1113 I changed this behaviour, the line is marked "dirty" as soon as you start editing
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Thank Matthias :-)
All is good now with GCC 1.1.1.3.
Thank
Bookmarks