Hello GHL'ers
I just made this DIY solution for my DC 1200 & DC 2000 Jebao pumps, it will only run the DC series of Jebao DC Pumps
it won't work on DCS/DCP or other models as these use another sinewave technology.
You'll need a RJ45 network cable and the LBF-AP breakout box from GHL and a voltmeter so you can measure that you have the right polarity and voltage on the right wires.
You also need the Jebao to apex converter.
LBF-AP is sold here :
https://store.aquariumcomputer.com/e...50_lbf-ap.html
And the Jebao to apex converter is right here:
https://www.ebay.com/itm/NEW-Jebao-J...MAAOSwhhpancLF
Cut the RJ45 Cable and strip the wires, then pin test the proper wires and mark them
Then open the LBF-AP and connect the RJ45 cable trought the lid of the LBF-AP box.
DIY LBF-AP MOD.jpg
NOTE :
Remember to double check everything
Neither I or GHL will be responsible for any broken circuits or damage on your equipment.
This is a do it yourself project and as such on your own risk, this being said, it should be both safe and fairly easy, mine is running fine
Cheers, Brock
Bookmarks