After Upgrade to 1.09 firmware my temp sensor showing 40 C.
Before I was 1.06 firmware, anybody have that and can share me ?
Or expalin why any update EB1 is fail ?
After Upgrade to 1.09 firmware my temp sensor showing 40 C.
Before I was 1.06 firmware, anybody have that and can share me ?
Or expalin why any update EB1 is fail ?
did you re-assign the EXB to PAB?
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Yes
please post a screenshot of
- System, where the EXB details can be seen
- temperature probe in question, where ADC values can be seen
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
you writebut the screenshot shows 1.08 for the EXB FWAfter Upgrade to 1.09
besides this, the ADC-values are wrong, they should be loaded from the EXB after assigning the PAB
so please do this:
1. PAB system reset
2. reboot controller
3. assign again
if the shown firmware version is still not 1.09 do the PAB update again
connect only the EXB during update to PAB
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
both
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks