1 - would difference in firmware cause communication problems between the 2 to effect PAR this much
no
I was thinking of old pucks but this doesn't make sense as the old lamp is giving the higher PAR.
right. and even if it was vice versa this difference would be more than unusual, the LEDs have >60000h lifetime in the Mitras (LH80)
3 - could there be a fault on the new lamp
I doubt that.
you write
exactly the same settings
does this refer to all setings?
- illumination run?
- energy options?
do the simple test:
all lamps to 100% and full output and 65°C (energy options)
in Master-Slave configuration: output manually 100% on all channels
now: all LEDs in both lamps on?
PAR readings similar (under similar conditions, of course)?
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks