I have finally managed to downgrade the firmware on my P3, its taken a total of 10 hours, the HV channel is now showing in the illumination overview tab but the hv channel is still not working.
I did find some anomalies while playing with the lamps however, in the pictures you can see the illumination run of my uv channel (it was like this is all channels, im using this as the example), the picture with the flattop, is the run from the program im using, the picture with the point at the top, is what was on each of my lamps, I had to load the lighting program to each lamp separately so the illumination runs all looked the same.
there is defiantly something wrong here guys, as I said before, what are the chances of ALL the uv channels blowing together?, and why do the illumination runs on the lamps match the runs in the GCC?
views and cures please guys
on lamp.jpg
after upload to lamp.jpg
Bookmarks