Hi,
I am in need of some assistance in terms of the correct parts, minimum components required to manage a series of 3 marine tanks and 2 snake cages.
Room One
The primary marine tank (this has the PII Plus Ex)
Room Two
Two marine tanks
Two snake cages
Both are in the same room and are physically close.
There is an RJ45 ethernet cable run between the two room and this is about 20m.
I would like to be able to perform the following
Manage the primary Marine tank
This currently has a Profilux Plus II Ex with
2 x Digital Powerbar's
2 x Level switches
2 x Tunze 6105 powerheads with L1, L2 and splitter cables
2 x Level sensors Level 1 and Level 3
1 x Temp Probe
1 x PH probe
1 x Redox probe
1 x Conductivity probe
1 x WLAN card (ethernet is also available at the location but not connected)
I have on order an upgrade to the Profilux III Ex for this system
For the second room
The two marine tanks are a quarantine and grow up tank
I would like to monitor
Temp, PH, Redox and Conductivity on each of these tanks seperatly.
The temp would then control the heater in each of these tanks seperatly.
I would like to be able to turn on/off the powerheads/pumps for feeding pauses.
What component list to I require to do this for the two tanks (or I am happy if the feading pause is common on these two tanks)?
For the two snake cages I would like to monitor the air temp and humidity in the cages.
Depending on these values turn on the pumps to cycle water and/or heat the cages.
Can you provide a component list that I would require to do this for the cages?
My ideal situation would be to use the controller to control and monitor the lot, then use software to be able to monitor everything from a PC.
Bookmarks