Originally Posted by
Lasse
I have some ideas that I should do the update with only the SMS modul connected to my Profilux PAB and use the commands below the Control Centers tab Extra/PAB/Firmware update and use the file ProfiLuxSMS_V303_boot.mhx but I need to have a confirmation of this from you because I have a rather complicated setup of other PAB devices.
Yes, this is completely right. Please pay attention that only the SMS-Module and no other PAB-device is connected to the PAB-Ports during the update.
Originally Posted by
Lasse
Today I have two different Profilux with their own PAB nets. One with two expansions boxes. one sms-module and 4 powerbars connected to PAB and one computer with two expansion boxes and two powerbars conected. I wan´t to connect this to one PAB net (and later on with more Profilux computers connected) just in order to use my SMS module for all of my Profilux. My ideas is to change my second computers device adress with help of Controll Center/communication/adjust device adress to 2 and create a PAB group 2 for that computers PAB net. Have I understand all correct?
One SMS-Module can only be operated with one Profilux system. So one module for two systems unfortunately won't work.
We can only recommend to use two SMS-Modules, for each system one.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks