Yes, you assign Temperature 1 and heater to the socket in which your heater is plugged in.
The time point when the heater is switched on depends on the hysteresis. In the case of nominal value 77 F and hysteresis of 0,396, the heater would turn on if temperature falls below 76,80 F.
Please have a look at the ProfiLux manual, chapter Hysteresis.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks