@Gunther
it was a general statement
@Gunther
it was a general statement
the PLM-DALI doesn't care what device type is connected
the broadcasted commands are valid for all device types, no special commands for certain device types are used
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
I use this driver
http://www.maffei-gmbh.de/downloads/...LLY_MAFFEI.pdf
sorry, wrong manual, I use this. It works with DALI and 1-10V
Now i have tried with a new driver.
It found the driver but after i have
New Numbering - Please wait - Found 1 ready
and after that
Assign illumination - Choose lamp - illumination assign <1> - OK - Please wait
The lamp switch off
if I draw out the dali cabel from the CARD the light switch on again
So one things is solved but the ligth still dosent light up.
Can some more help me if i doing wrong?
Here is some movie about it
http://youtu.be/XxpliDsnRgE
I tried again and now with number 0 in illumination assign and now it works
But can some one explain about the MIN Dimlevel DALI thing it says 85 but what happens if i change it to 0 or 200?
Bookmarks