Quote Originally Posted by -Aaron- View Post
1- In PLC I press transmit the illumination run to the lights, presumably it does this wirelessly?

2 - Yes, I've checked the correct wireless channel and address is set up in PLC as well.

3 - There is nothing in some of the channels and a couple look wrong.

1.jpg2.jpg3.jpg


4 - this works fine.
1.)
Working in the light composer:
The settings are transmitted to the light channels of the ProfiLux. Then click Save, the settings are held in the ProfiLux now.
ProfiLux broadcasts these settings to the lamp, the lamp keeps these settings temporarily and works with them.
Remember: The settings are kept (and edited) in the ProfiLux- the Mitras is a "stupid" slave device now.

3.)
Check the channel assignments in the light composer. If you use a template or a lc project from GHL Control Center they should be correct.

PS:When I check your light composer screenshot I see that you have always the same light color, at every time. Therefore always the same LEDs are active. I think the problem is in the light composer project.