BTW - it is easier to make a screenshot than to take a photo
press CTRL + PRINT and the screenshot is in the clipboard
or use the snipping tool which come with Win 7
there are also many other options
you need 2 different functions for filling:
one socket should have the function fill (AWC) for salt, the other fill (ATO) for RO
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Hey mate thanks for your reply
I can't fine the print button but any way
Is this right if I have it like this
Programmable logic
G6 fill water 2 AND con decrease
G7 fill water 2 AND con increase
G8 water change inverted AND Drain water 2
G9 water change OR fill water 2
Socket function
S12 programmable 6 (ATO RO)
S16 programmable 7 (ATO SALT)
S17 programmable 8 ( drain water 2)
S18 programmable 9 (fill water AWC 2)
Level 2
ATO & water change
Sensor 2,3
Does this help with any think
Thank you Joel
Sometimes the keyboard button is labelled Prt Scr. You may also need to press a Function key.
Sent from my iPhone using Tapatalk
why so complicated?
is it really necessary to involve the salinity measurement in the refilling?
can't we just assume that RO water has to be refilled during ATO, and salt water is refilled during AWC?
then we don't need any prog. logic, just the 2 socket functions fill (ATO) and fill (AWC)
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Can you give me a example
Or like this
G6 fill water Ato&awc 2 and cond decrease
G7 fill water Ato&awc 2 and cond increase
S12 programmable 6 (RO ATO)
S 16 programmable 7 (salt ATO)
S17 drain water inverted
S18 fill water 2 ( not sure but would u inverted it )
Last edited by coops1234; 03.06.2013 at 08:05.
Still not going
Got the drain going its not inverted
It just the filling up
the pump comes on but the ATO is trying to control the salinity still
Is it cos I'm using one seasor for drain and seasor for ato,salinity control and water change
Also when salinity is high and goes to top up the water change pump comes on to
As well when it's low
Need help with this soon as going back to work for a month and my wife won't touch it lol
Last edited by coops1234; 03.06.2013 at 16:59.
Bookmarks