Expansion cards for level inputs!

[BigAl07]

Matthias or aqua_digital some extra informations about it?
I can't order it without more information about how it works.

I'm not exactly sure what you're looking for but I'll try to help

Here's a picture of them (both in one picture)



PL-0871
PLM-4Level:
1 adjustable galvanically insulated input for pH-value probe or redox probe
2 inputs for level- or flow-sensors

PL-0872
PLM-4Level:
2 ports with 4 level inputs in sum (able to add 4 additional level or Flow inputs from a single card)


These should be available just about any time now from your local GHL dealer. I would think that if you plan to fully utilize the available level/flow ports you'll need the appropriate splitter for that per port: PL-LY (PL-0081)

[smithpl]

Thanks BigAll,
now is clear.

I thought this is module with the input of a linear measurement but it's only input module with 0/1 state.

thanks a lot :-)
M.

[BigAl07]

Thanks BigAll,
now is clear.

............

thanks a lot :-)
M.

You're very welcome. I get lucky once in a while and stumble across a correct answer

[doggydoc10]

Question for GHL brass. I purchased my level sensor car but I was told I cannot use it on my expansion box. Is that correct?



Doggydoc

[JasonK]

While I'm not brass (I would consider myself more Platinum standard ) There is reference from one of the GHL brass here which states the expansion box will need a firmware update which is still in development for the new level cards to work : http://forum.aquariumcomputer.com/sh...o-flow-sensors

[CaptCrash]

Hi Matthias (and others at GHL),

Is there a target date for the expansion box firmware to support the new cards?
I have a few changes I would like to implement that require more level sensors and I would like to be able to order the parts, once they are usable.
Im about to be away for a few weeks, and It would be good to be able to order the bits and have them ready for when I get back (assuming the firmware is soon).

thanks in advance.

[Matthias]

support for level cards in the EXB should be finished in 4 weeks

[CaptCrash]

support for level cards in the EXB should be finished in 4 weeks

Thats excellent, thanks for the quick response.

[Al Locke]

Will this update include support for the flow sensors with the level card in the EXB too?

[Matthias]

I can't promise, the focus will first be on the level control support