Is there a place in the PC program where you can see that the dosser is working and total amount that each pump has dossed. I have tried to find it but just can not find....
Is there a place in the PC program where you can see that the dosser is working and total amount that each pump has dossed. I have tried to find it but just can not find....
profilux 3x wireless enabled 3 ecotech pumps and wireless adapter
3 Simuspots 2 levl sensors ( min /max)
4 channel dossing pump 2 PAB 6 outlets
Temp PH and redox sensors 2 mitras 6100HV
touch Condutivity sensor wireles card
Under System/ Socket functions you can see if a socket (or here dosing pump) is on or off.
ok if I understand I will only see it work if I have gone to sockets and see it turn on. if so then this is how I set it up S4 is pump 4 and I want to dose 5ml 2 times a day. I went to timer 4 set auto dose, 5ml and dose 2 times .. every time a check control software it says off......Andre
profilux 3x wireless enabled 3 ecotech pumps and wireless adapter
3 Simuspots 2 levl sensors ( min /max)
4 channel dossing pump 2 PAB 6 outlets
Temp PH and redox sensors 2 mitras 6100HV
touch Condutivity sensor wireles card
I also do not see dosser when I click on system and see profilux and ext card also see pabs and vortec controller but no dosser ...Andre
profilux 3x wireless enabled 3 ecotech pumps and wireless adapter
3 Simuspots 2 levl sensors ( min /max)
4 channel dossing pump 2 PAB 6 outlets
Temp PH and redox sensors 2 mitras 6100HV
touch Condutivity sensor wireles card
It´s already said: Under System/ Socket functions you can see if a socket (or here dosing pump) is on or off.I also do not see dosser when I click on system
From the point of control there is no difference between socket and dosing pump
It´s not visible as dosing device
Bookmarks