Ok thank you Michael.....I am going to continue playing around with it.....some other support is much appreciated!
Sent from my iPad using Tapatalk HD
Ok thank you Michael.....I am going to continue playing around with it.....some other support is much appreciated!
Sent from my iPad using Tapatalk HD
I have noticed that if I set my sensor 1 to 11 and sensor 2 to 4 then it calls for rodi ato fill.....this happens no matter what control cir... Number I choose.....look at these pics....
Sent from my iPad using Tapatalk HD
It's like as though I just don't have the right sensor setup.....weird though it calls for fill when sensors as setup that way and yet when setup as 3 and 4 nothing happens.....
Sent from my iPad using Tapatalk HD
Now that I have reset my pab and reassigned my devices it is now working properly.....however, the optical sensor is extremely sensor....it constantly actives and then deactivates constantly for about a second.....is there anyway to change this so it will activate less often but for a little longer time??
Sent from my iPad using Tapatalk HD
Ok thanks I will try that....it is currently set to 1 second.....I am worried that by doing this it will also affect my awc because I only have the two sensors and have them used as sensor 1 and sensor 2 in the ato & awc feature under levels in the software.....how will this affect awc??
Sent from my iPad using Tapatalk HD
I dunno? Give it a shot. If the AWC doesn't work afterwards, maybe that's why I never got the AWC to work for me! Probably not, but who knows.
Did u start a thread regarding your awc issue?? Do you have same setup as me?? I mean like are u using two optical sensors for ato & awc??
Sent from my iPad using Tapatalk HD
Yes (except I was using one optical and one float), but as you can see in the other thread I started on the N.A. forum, I decided it wasn't really for me so I do it a bit differently.
http://profiluxsupport.com/showthrea...-s-AWC-and-ATO
Ok yes I did see your post there......
Sent from my iPad using Tapatalk HD
Bookmarks