From April 2012 we can offer a flow sensor for the ProfiLux!
FlowSensorWithCableWithBG_600x290.jpg
read more:
http://www.aquariumcomputer.com/Syst...cessories.html
From April 2012 we can offer a flow sensor for the ProfiLux!
FlowSensorWithCableWithBG_600x290.jpg
read more:
http://www.aquariumcomputer.com/Syst...cessories.html
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Good news and most welcome!
Any plans to offer this for the pond as well?
/ ganesh
this is a GREAT addition to the ProfiLux accessories! I can so see this being a valuable tool for many of us.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Don’t get it.
PL-0867: Measurement range 300–5000 l/h, Nominal width DN20, 2x G1" outside thread.
In koi-ponds we have a flow ranging from 16.000–60.000 l/h and more.
??
/ ganesh
then the flow sensor should be operated in a bypass, like the other sensors pH and temp etc.
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Will that give correct measurements/readings of the flow rate?
Last edited by ganesh; 06.03.2012 at 21:06.
/ ganesh
Matthias
Does the flow sensor transmit on and off signals with varying frequency like the flow sensor in this video?
http://www.youtube.com/watch?v=GmTmD...e_gdata_player
So the Profilux level input is not a 0 to 10 volt analog input.... or is it?
yes, we count pulses per second
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks