Sorry, me again.
It is the SWIC token to display the current of the switch. If I take it out it works. Could it be because the first four switches are the dosing pumps and the PAB bar starts at switch number 5?
Thanks
Sorry, me again.
It is the SWIC token to display the current of the switch. If I take it out it works. Could it be because the first four switches are the dosing pumps and the PAB bar starts at switch number 5?
Thanks
Check your firmware version. Some of the tokens are brand new and not supportet with older by older firmware versions.Is there anything obvious that I am doing wrong?
Thanks Wirus, that was my first thought as well but I have the latest Firmware, 5.11. I have managed to configure the use of PLC from outside the house so I guess it is not that important because I can always check it using PLC if there is an alarm. Any more thoughts on this will becreally appreciated as I am on a very steep learning curve...
Thanks.
I think you forgot somewhere a $
e.g.
SENV[xx]$$ is wrong, it must be
$$SENV[xx]$$
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Hi Matthias
Sorry, yes I found that bit. Even though I had been looking for ages at the code I did not see it until I posted it here. Typical!!
It is the other bit, the one about the switches that I cannot figure out.
For switches I use this loop
$$REPS[32][02]$$ $$SWID[xx]$$ - $$SWIS[xx]$$ [$$SWIC[xx]$$]
$$REPE$$
description , state , current
I get this output
( plz remember this is displaying the description set in the profilux ( if you didn't set this the description could have funny chars in the email )
ps: its wise to use a short desciption ( 16 chars otherwise it gets cut off in the message )
Heater Temp2 - On [0.0 A]
Chiller Temp3 (v - Off [0.0 A]
verlichting disp - On [0.1 A]
verlichting disp - On [0.0 A]
verlichting disp - On [0.0 A]
verlichting disp - On [0.3 A]
Heater Sump Temp - On [0.0 A]
Koeler Temp 3 (v - Off [0.0 A]
ATO zoet - Off [0.0 A]
Sturing Magneet - On [0.0 A]
Dosering kalkrea - On [0.0 A]
Verlichting Sump - Off [0.0 A]
Bookmarks