Hi,
I see in the downloads there is a touch firmware 1.01 which is dated 2011-11-10, is this new?
What is the change log for this??
Hi,
I see in the downloads there is a touch firmware 1.01 which is dated 2011-11-10, is this new?
What is the change log for this??
Last edited by richard.mayo; 12.11.2011 at 03:56.
Do not think so, because my Touch has already firmware 1.06
i thought it seemed strange
the current Touch-firmware is 1.01
1.02 is coming this week!
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
great stuff, looking forward to it.
In that case I think that there is a little bug in the ProfiLuxcontrol software, because it tells me that my Touch has firmware 1.06 (see screenshot). But when I look at my PAB powerbar, it sticks out that this one does have firmware 1.01(see screenshot).... perhaps the two are switched somehow or is it just a coincidence?
touch_firmware_version_buggie.jpg
pab_powerbar_firmware_version_buggie.jpg
Please reassign the PAB devices again to ProfiLux
Close PLC connection
ProfiLux menu:
"System" -> "Configure PAB" -> "Assign devices" -> no need to change settings, just press enter
After then, PLC should display the correct Firmware versions after reconnect
week ends on Sunday 23:59:59
No support or warranty issues over PM! Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Kein Support oder Reklamationsabwicklung über PM! Bitte senden Sie an die Moderatoren nur PMs bei allgemeinen Problemen mit der Verwendung des Forums! Danke dass Sie uns dabei helfen, den Support effektiv zu gestalten.
Bookmarks