Firmware 5.05f for PII and P3 has release state

[Matthias]

version 5.05f has been Release for a while now, even the new produced P3 have this firmware

about 800 users have downloaded 5.05f so far, considering this large amount 5.05f versions running I don't think there is a general problem with this version

I have another idea: Maybe the setting "EHEIM-controller availabe" is accidentally activated?

[diverdutch]

Matthias, txs for reply.

I will download again today. Can you confirm me if the following procedure is correct.

I will save all current setting of my profilux II as also my sensor settings. I connect my PC with PLC5.042 on the PLII true USB-RS32 cable.
I will use the PLC to upgrade firmware 5.05f version and confirm on the PLII with YES and than click ok on PLC. When sign from the PLC shows updrade succefull, than i have to reboot my PLII?
After reboot the PLII loads standard settings. Than make connection again with PLC and transfer old PLII settings back to the PLII and the same with sensor settings.

Now where can i find these EHEIM controller? and when do i need to check this, before uploading settings? or firmware update?

Please let me know if this is correct or i have missed something. thanks for assistance...

[Matthias]

yes, this is all correct

reboot starts automatically

EHEIM is under extras

[diverdutch]

Matthias,

Txs for the reply. I have succefully upgraded to the new PLC5.06 and firmware v5.06 and all works accordingly.