I cant find a thread about Low / hight salinity and take from diffrent barrels

[wrang]

Hello
I can not find the thread there was someone who explained how to set the value too low or high salinity.
When salinity is low so it shall start a pump from a barrel 1 and when the salinity is high, it shall take water from barrel 2 (Osmoswater)

[Blahenazo]

this should get you started (untested)

don't forget your level sensor that will trigger the whole process ( you don't want to add water to a tank , unless you keep track of the level of your tank )


logix 1
water 1 and Cond decrease => add socket to salt ato pump

logic 2
water 1 and cond increase => add socket to fresh ato pump


ps when you setup ATO its important to play with max ontime and reaction time => also the option ATO (always on is needed)

Small remark:
I'm shooting my on foot here but I think this logic could fail if the max ontime is short and if the cond if spot on => no decrease of increase => level sensor could be in error after max on time (if alarms are active)

maybe GHL can answer this .

[wrang]

Thanks