Pro Plus II, Slave doser, latest firmware and software installed. I still cannot get the doser to run after multiple programming attempts. I have it set up this way:
The power bar is programmed 1-6 on the timer. Doser is 7 & 8. Both were setup/programmed disconnected per the manual. I have timer #7 set at 1230pm to run for 1-min (part A). I have timer #8 set at 1235pm to run for 1-min (part B). Set to run 7-days a week. The doser is plugged into a seperate wall outlet so that I don't use up one of my six power bar programmable outlets. Power indicator and com lights on the doser are lit/on. The com cable comes out of Pro II to the six bar, out of the power bar to the doser. The doser can be run in manual using either the software or manual buttons on the front of the doser itself. Setup is saved and loaded.
I tried programming/running the doser in auto mode prior to this with the same end results - nothing.
What am I missing and/or doing wrong here?
Bookmarks