Hi,
I also need some help with the programming of the profilux II

I need to find out if it is possible before buying the sensors and switch blocks.

I have an 60 ltr Osmose tank in wich I want place 2 sensors ( Sensor 1 and 2 )
Into the bottem of the osmose tank the water is flowing to my aquarium. If the tank is full it takes 3 to 4 days when it is empty again.

Sensor1 is the upper sensor and says the tank is full.
Sensor2 is placed where the tank is about 70% filled.
S5 is handling the magnetic switch for the Osmose water ( KO )
S6 is handling the magnetic switch for the Drink Water ( KW )
S7 is an air pump wich will mix the Osmose and Drink Water.

Let start with an empty tank.
Sensor1=0 , Sensor2=0 , S5=1, S6=0, S7=0
Tank starts to fill with Osmose Water.

Then the water reach Sensor 2.
Sensor1=0, Sensor2=1, then S5=1, S6=1, S7=1
Tank is stiil filled with Osmose Water but also filled with Drink Water.

Then the tank is full
Sensor1=1, Sensor2=1, then S5=0, S6=0, S7=1

Then if the water lowers sensor 2
Sensor1=0, Sensor2=0, S5=0, S6=0 then S7=0 after x hours
Shut off air pump after x hours

Then the sequence starts again after 3-4 days.

Is it possible to do with the ProfiluxII ?
How to do ?

I think this will be an exam question ;-)

Kind regards,
Martien