Profilux 3 to Profilux 4 upgrade

[chema61]

I'm in the process of upgrading from my old Profilux 3 to Profilux 4. Before reading some posts about this I saved the Profilux 3 settings and sensor data and downloaded them to Profilux 4. While doing this the Profilux 4 was only connected to the computer as I was doing the transfer via GCC. P4 got some settings but not all of them. Then I read that you can not transfer settings and data from P3 to P4.

Now I'm worried whether I may have damaged P4 or whether I should reset it.

Another thing that worries me is that once I powered up P4 (at the very beginning, before transferring any settings) I only got alarm messages in the display but no menu. Is that normal?

Thank you for your help

[Gael]

Hello,

I advise you to perform a factory reset.
If necessary, don't hesitate to open a support ticket.

Gaël