Do you know how much Ohm te probe should have
Wen masure the probe is like 650 Ohm at 25 degrees
I brought a New one but its a BNC connector. That 1 is like 1100 Ohm .. was hoping there the same so i could change connector.
Do you know how much Ohm te probe should have
Wen masure the probe is like 650 Ohm at 25 degrees
I brought a New one but its a BNC connector. That 1 is like 1100 Ohm .. was hoping there the same so i could change connector.
New from where?
GHL temperature sensors with BNC connector are not PT1000 but digital chip.
Gaël
No support or warranty issues over PM!
Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Creating a support ticket
For support or warranty issues, create a support ticket by clicking here.
LSF .. he told me that the mini din connector pt1000 are old. And that i could use the one with bnc connector but have to switch connector.. Il bring the probe back to him and try to find he right 1
Can u tell me if this the right one pl-0094
Screenshot_20230130_120933_Samsung Notes.jpg
Thx for you Quick reply
Last edited by GUPSTER; 30.01.2023 at 12:15.
For P3: PL-0094 https://store.aquariumcomputer.com/e...-aquarium.html
(Or PL-0538 for measurement in pond range https://store.aquariumcomputer.com/e...nsor-pond.html)
Gaël
Last edited by Gael; 30.01.2023 at 12:24.
No support or warranty issues over PM!
Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Creating a support ticket
For support or warranty issues, create a support ticket by clicking here.
New probe is arrived..
Should i change anything in setting.
Calibratie data see screenshot
Screenshot_20230131_183509_GHL Connect.jpg
Hello,
Never edit calibration values of the temperature sensors:
temp.jpg
Gaël
No support or warranty issues over PM!
Please send PMs to the moderators only if you have general problems with using the forum! Thanks for helping us to keep the support efficient.
Creating a support ticket
For support or warranty issues, create a support ticket by clicking here.
New probe installed ad 18.30
Start temp 24.5 the powerbar is working so my heater is now 1 hour on real tank temp is 25 now but the profilux say my tank is 23.4 and still keep my heater on.. i see the temp. Still Lowering on the profilux
Looks like my profilux is not working correct any more.
New probe works the same as the old probe..
Wen installed probe i keep the New probe away from any other powercords.. so there is no interverensScreenshot_20230131_192943_GHL Connect.jpg
Now i use the option on the profilux.
Fix dig. Temperature sensor issue
And correct the temp. Conform my analoge tempature.
What can i do more?
Last edited by GUPSTER; 31.01.2023 at 19:59.
Bookmarks