-
Doser 2.1 Slave
Hallo Zusammen,
ich habe folgende Konfiguration:
Doser 2.1 SA (4fach) Firmware 1.27
Seit heute KH Director und einen Doser 2.1 Slave mit 3 Pumpen.
Das Einbinden etc hat alles wunderbar geklappt.
Allerdings ist es im Moment so, wenn ich Pumpe 1 ansteuere, läuft die Pumpe 1 am Slave mit?!
Das ist auch mit den anderen Pumpen so.
Ich möchte die Pumpen unabhängig voneinander steuern.
Was mache ich an der Stelle falsch?
In meiner Naivität hatte ich gedacht, dass beim Slave die erste Pumpe dann "Pumpe 5" ist.
Danke und Gruß!
hat sich erledigt.
Die Nummerierung der Pumpen!
Last edited by andber; 15.02.2018 at 20:04.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks