Hi,

I have a flow sensor for my Profilux3 and was hoping to find some videos or at least some photos / diagrams of how to connect it to my existing plumping.

I have read through the instructions from GHL but its a one page doc without any diagrams.

My plumping is using soft piping.
I also have a media reactor off my return pump.

Does anyone have any photos, youtube videos or step by step instructions on what fittings they needed to purchase and how they fitted from this device to their return pump, plumping etc?
Where should i place this sensor?
It has some threads on it but my plumping is connected to my return pump with cable ties, so what do i need?


Thanks