Temperature calibration

[Gael]

Hello,

I know you say temperature calibration are useless because are done by GHL at factory.
But I have a ProfiLux 3.1T eX with a temp probe and a ExpansionBox with a temp probe.
The 2 probes are for test at the same place and they never show the same temperature…

I write down the original ADC1 & DC2 value for both probes:
Profilux: 604/247
Box: 645/271

And use the lowered/reised with the Adjust temperature tool to set the same temp.

But if they show the same temp at 25° the temp differ at 20° or 30°, that mean this don't work.

The problem is that we can't find the good ADC1 and ADC2 value to set to each sensor because we can't see current ADC value
If we can see current ADC value we can with check water at 20° and at 30° find the good ADC1 and ADC2.

Please can you add the current ADC value somewhere.

Thank