LEDs erratic with EVG-AP-2f-HIC

[funkyaneurysm]

Hello,

My LED unit is not working as required via the EVG-AP-2f-HIC.

I have just installed the EVG-AP-2f-HIC on my Profilux 3.1N (6.11). It is hooked up to a Meanwell ELN-60-48D powering 13 or 15 (tried both amounts) Cree LEDs.

This LED unit worked fine for years prior to connecting it to the EVG.

Oddly, the LEDs seem to respond to channel 2.

Below is a table of LED responses to given Profilux commands from the Illumination screen of ProfiluxControl. I have listed the response of the LEDs when changing from one state to another via ProfiluxControl's Illumination screen.

0.5 second flash at about 100% When adding channel 1 and 2 after no channel active
Slow fade from 100% to 20% then LEDs turn off When deleting channel 2 after both channels active
No light When adding channel 1 after no channels active
No light When deleting channel 1 after both channels active
No light When adding channel 1 after only channel 2 active
Slow fade from 100% to 20% then LEDs turn off When deleting channel 1 and 2 after both channels active
No light When deleting channel 1 after only channel 1 active
fade up from 0% to 10% then fade back to 0% Takes 3 seconds. When adding channel 2 after no channel active
fade up from 0% to 10% then fade back to 0% Takes 3 seconds. When adding channel 2 after only channel 1 active
No light When deleting channel 2 after only channel 2 active

Importantly, I'm not planning to open an aquatic disco. Otherwise, this performance would be perfect!

Any ideas would be greatly appreciated.
Thanks,
Andrew