I have a store and my coral tanks are on my p3 n controller. I have a conduct probe and setup my programmable logic to dose either ATO Fresh or ATO Salt depending on salinity. The issue I'm having, it will not pump salt mix if the Salinity is set in the hysteresis. So I get a ATO Alarm go off.

So the question is how do I have the programmable logic pump salt mix even if the Salinity is at the right spot. Just to top off salt water until the level sensor tells it to stop.

Here is a picture of my programmable logic G2 for Salt Mix

ATO Salt.jpg

Here is the options I can select.

ATO Salt Options.png