Hi

I have been trying to simulate with my profilux something that I used to do with my Tunze controller: a desedimentation storm. It is just running the tunze pumps in a certain (different) sequence at high intensity for a few minutes each day so that the sediments are lifted and can be taken by the filtration.

I have been playing with the storm mode of the profilux but the only thing that I seem to be able to do is to increase the maximum of the pumps but it still follows the same pattern (alternating) as before. I found an old post asking about the same but unfortunately there was no answer at that time.

Does anybody know if there is a way of programming the profilux to change the pattern of the pumps for just a few minutes a day?

Thank you very much