Powerbar 5.1 - PAB PROBLEM

[wrang]

Hello.
I have a powerbar PAB that no longer works, has searched for it in the GHL computer. Its worked yesterday, has tried to change cable. Is it broken or can it be repaired?

[Gandalf]

check the fuse and use the old cable again.

[wrang]

The fuse is ok
When i use the pAB kabel it alarm in the GHL computer and cant find the powerbar


Skickat från min iPhone med Tapatalk

[Vinny]

If you recently attempted a PAB-device update for another device other than the PB5.1, but left the PB5.1 connected, that will cause this problem. The device received the wrong FW.
Please follow the emergency PAB-device update steps as shown here:
https://www.aquariumcomputer.com/kno...r-pab-devices/

[wrang]

If you recently attempted a PAB-device update for another device other than the PB5.1, but left the PB5.1 connected, that will cause this problem. The device received the wrong FW.
Please follow the emergency PAB-device update steps as shown here:
https://www.aquariumcomputer.com/kno...r-pab-devices/

Hello
No update at all in The system

But if the pab dosent work, i cant do a update ??


Skickat från min iPhone med Tapatalk

[Vinny]

Did you take a look at the steps?
The answer to your question is there.

[wrang]

Not yet i Will test as it says


Skickat från min iPhone med Tapatalk

[wrang]

[mention]Vinny [/mention]
Hello now i have Done as it says in the text
In the last step it says
Error while transmitting firmwire.

I have test the both PAB connection


Skickat från min iPhone med Tapatalk

[wrang]

Now i get this error


Skickat från min iPhone med Tapatalk

[Vinny]

Make sure you are connected over USB and choosing the "firmware update" button under the PAB-devices section.
NOT the maintenance section.

If issue continues, please open a support ticket and provide these details, screenshots, serial number of your PB and sales reciept.