Cannot see PAB devices (powerbar & touch) after upgrade to 6.1.4

[StAlbansJake]

I've just upgraded to 6.14 (from 6.12) at the same time as moving to a new tank. (whilst all equipment is the same I may have put the PAB devices in a different order in the chain).

Everything works fine (PAB powerbars and Touch) - however I can't see the Powerbar and Touch under 'system' like I used to be able to.

Is this me and I need to reset something, or something with the new firmware or GHL control centre?

anyone else got this problem?

[Artur]

Hello,

i checked it and everything seems fine.
You should do a PAB reset and assign the PAB devices again.
For that you navigate in the ProfiLux menu to System -> Configure PAB -> PAB Systemreset.

[kwiatek]

I have that same problem look
profilux.jpg

[Artur]

Did you a PAB reset and assigned the devices again?

[kwiatek]

Yes !!!
I turn off power from PAB,but You don't see Profilux do't see PAB !!!

[Artur]

Hello,

i checked it and everything seems fine.
You should do a PAB reset and assign the PAB devices again.
For that you navigate in the ProfiLux menu to System -> Configure PAB -> PAB Systemreset.

Did you reset the pab and assigned the device again?

[kwiatek]

Did you see this option ?? I don't have this option !!!
Look Picture!

[Artur]

Directly on the ProfiLux not in the software.

[kwiatek]

Is ok ,
That same situation after restore setting should be remember by system !!!!
It's not wish !!!
it should be standard

[shaggss]

I am having some trouble.

1. I have as in post number 2 - PAB Systemrest
2. Amber comm light is on the Powerbar 5.1
3. Powerbar is connected to P3 via PAB cable and PAB socket on back of P3.
4. I have an old Powerbar connected to P3 in socket S1-S4
5. I can assign functions to S1 but it effects both S1 sockets on the new 5.1 Powerbar and the old Powerbar!
6. I cannot see the new 5.1 Powerbar in the software
7. Firmware 6.15
8. What is the firmware for the 5.1 Powerbar?