Cannot see PAB devices (powerbar & touch) after upgrade to 6.1.4

[StAlbansJake]

I've just upgraded to 6.14 (from 6.12) at the same time as moving to a new tank. (whilst all equipment is the same I may have put the PAB devices in a different order in the chain).

Everything works fine (PAB powerbars and Touch) - however I can't see the Powerbar and Touch under 'system' like I used to be able to.

Is this me and I need to reset something, or something with the new firmware or GHL control centre?

anyone else got this problem?

[Artur]

Hello,

i checked it and everything seems fine.
You should do a PAB reset and assign the PAB devices again.
For that you navigate in the ProfiLux menu to System -> Configure PAB -> PAB Systemreset.

[kwiatek]

I have that same problem look
profilux.jpg

[Artur]

Did you a PAB reset and assigned the devices again?

[kwiatek]

Yes !!!
I turn off power from PAB,but You don't see Profilux do't see PAB !!!

[Artur]

Hello,

i checked it and everything seems fine.
You should do a PAB reset and assign the PAB devices again.
For that you navigate in the ProfiLux menu to System -> Configure PAB -> PAB Systemreset.

Did you reset the pab and assigned the device again?